• Sprayed in microdoses
• Provides ideal prevention
• Decarbonizes compression and oil scraper rings
• Cleans in 15 minutes
• Restores compression when deviation from the norm is up to 10%
• Recommended for oil consumption of up to 100 ml per 1000 km on naturally aspirated engines and up to 500 ml per 1000 km on turbocharged engines
• 1 cylinder is designed to treat 20 cylinders
• Does not require special equipment
• The procedure does not require an oil change.
• Long tube 60 cm for spraying the composition

Specifications

• Product type: decoking
• Application: compression rings, oil scraper rings, piston surface
• Type of decoking: aerosol, foam
• Problems: compression deviation, increased oil consumption, pollution prevention
• Engine capacity: from 2 to 4 liters
• Oil change: not required
• Duration: up to 30 minutes
• Container type: aerosol

Liquid composition in an aerosol with a fast-acting formula. Specially designed to effectively solve the problem of coking of piston rings at their initial stage. Equalizes compression in cylinders and prevents increased oil consumption.

Shake thoroughly before use!

Use at cylinder temperature above +15°C.

1. Warm up the engine to a temperature of +70°C.
2. Turn off the ignition system. Remove the spark plugs on a petrol engine and the glow plugs or injectors on a diesel engine.
3. Using the extension tube, spray the composition (up to 3 seconds) into each cylinder.
4. Screw in the spark plugs (injectors) and wait 15 minutes. 
5. Unscrew the spark plugs (injectors). Cover the technological holes with a thick cloth and turn the engine with the starter for 5-10 seconds.
6. Install dismantled units and parts.
7. Make sure the assembly is correct.
8. Start the engine and let it run for 10 minutes, periodically gradually increasing the speed to 1500 – 2500 rpm.

One application is allowed between engine oil changes!

If the dosage or the recommended number of procedures is exceeded, make sure that the paintwork of the oil pan is intact. If necessary, remove and mechanically clean the oil pan and oil receiver mesh. Change oil and oil filter!